Custom LED 10 Pattern Electronic LED Flasher Relay for LED Blinkers on Motorcycles

Introducing the Custom LED ELFR-P Programmable Electronic Flasher Relay! This micro controller based, plug and play flasher relay has 10 preprogrammed user selectable flash patterns! The flash pattern is easily selected by a 10 position rotary switch conveniently located on the compact unit. This flasher relay system will operate properly and consistently for blinker loads ranging from 0.1A to 5A, which basically covers any combination of any blinker products on the market! The fuse protected 18" long harness allows for plug and play* operation for motorcycles listed in our compatibility list below. For motorcycles not on the list, the unit may be hard wired to any motorcycle with a two wire flasher relay, or three wire flasher relay system where the third wire is a ground. The extra long harness length, and compact overall size (2.36" X 1.68" X .67") allows for convenient mounting of the flasher relay, for easy access during flash pattern selection. * in addition to the direct plug and play connector, a single ground wire with affixed loop connector must be connected to a common ground point - such as the frame or battery negative terminal. Each flash pattern was optimized for effectiveness when used with ANY type of blinker indicators such as: LED blinkers, stock blinkers, incandescent blinkers or integrated LED tail lights! There are several different flash patterns ranging from DOT (stock) blink patterns to super intense strobing patterns to slow fading patterns. You can be sure to find a pattern that suits your taste!

• Features 10 user selectable blinker flash patterns ranging from DOT to intense strobe modulations. Maintains programed blinker flash rate for a wide range of LED and non-LED blinkers. Plug and play connectivity with OEM connector (see compatibility list). Recommended accessory for all Custom LED Integrated LED Tail Lights. 1-year Warranty & Satisfaction Guarantee!
• NOTE: In some rare instances, when there are NO incandescent loads on the blinker system (LEDs front and rear), one pair of our Stage I Load Equalizers will also be required to prevent a wide range of blinker problems. These problems are all associated with a lack of resistive load on an all-LED blinker system that was designed for incandescent lamps. Contact us for more information.